Let Eagle Computer and Automation Services plan out your lighting scenes and installations. We install and program several lighting system components from HAI, Leviton, and Lutron.

HAI Advanced Lighting Control (ALC) is intended for installation in homes, which have been pre-wired for installation of ALC system products. OmniLT, Omni II, and OmniPro II systems control lights and appliances by sending commands over the ALC signal wiring to ALC Switch Modules.

ALC Switch Modules communicate with the OmniLT, Omni II, or OmniPro II controller over low voltage signal wire. They are two-way devices, so the controller always knows the actual status of the switch. In addition, any ALC switches can be used to set scenes by triggering macros in the HAI controller.

Five types are available:

• Relay Switches for on/off control of lighting/power loads (i.e. fluorescent lights, ceiling fans, wall receptacles, etc.).
• Dimmer Switches are for incandescent lighting control. These modules are capable of being dimmed, brightened, set to a level. It is also possible to ramp the lighting level to a new level at a selectable ramp rate.
• Auxiliary Switches are used for multi-way control of a Relay or Dimmer Switch. This is a "slave" switch which is directly wired to a Relay or Dimmer Switch.
• Program Switches are used for executing macros within the controller (i.e. lighting scenes, temperature control, security, etc.).
• 4 Button Scene Switch Modules are used for executing macros within the controller. Each 4 Button Scene Switch Module resides on a single ALC address but can execute up to 4 unique macros.